Industry News

Push button switch manufacturer reveals disassembly method for you

Views : 2457
Update time : 2021-04-25 10:01:49
     Switch button how to disassemble and assemble, the first step is to prepare special tools, a small straight-shaped screwdriver and a large cross-shaped screwdriver. The first step is to open the back cover of the wall switch. Generally, we can see an opening of about 0.5cm under the back cover. We can open the back cover from here. Then take out the small straight-shaped screwdriver in the special tool we prepared before, and slowly tilt the rear cover plate forward from the opening position, and then it is easy to take it out.
After opening the rear cover, we still cannot see the fixing bolts. We need to take out the panel switch, and then use a small screwdriver to carefully pry the panel switch forward, in this way, the panel switch will fall off by itself. Then you can take out the second panel switch according to the above method, and then you will see the two fixing bolts on the mounting frame. Use a Phillips screwdriver to rotate counterclockwise to take out the entire wall switch. After taking it out, replace the new wall switch according to the original wiring method. Normally, the terminal of L is connected to the wire, L1 or L2 is connected to the lamp wire.
When the switch is disassembled, remove the waterproof cover outside first. We can see a small gap on the side of the waterproof cover, use a small straight-shaped screwdriver to insert it and knock it hard to take out the waterproof cover. After the mask is removed, you can see screws on both sides, unscrew the screw switch and open it naturally. After turning on the panel switch, we need to replace it with a new one. We will remove the wires on the old panel switch and then re-fix it to the corresponding position of the new panel switch. Under normal circumstances, there will be at least five wires on the switch of Yuba, two wires for heating, one wire for ventilation, one wire for lighting, and one wire for live. We will change all the five wires to the new panel switch and then install them according to the original steps. After the final installation, we will open the main gate and try it out.
Related News
Read More >>
The Munich Show in Germany is about to begin The Munich Show in Germany is about to begin
Nov .14.2022
We will present our latest pushbutton switch above in Munich, Germany 2022 from 15th to 18th.
The three major requirements for button switch installation cannot be ignored. The three major requirements for button switch installation cannot be ignored.
Sep .23.2022
Generally speaking, in order to make the button switch more accurate and sensitive during operation, the key is to master the relevant technical requirements during the installation process, so as to be more efficient and efficient in operation. Therefore
A start switch, a stop switch, control three-phase motor, how to connect? A start switch, a stop switch, control three-phase motor, how to connect?
Aug .20.2022
In the figure, SB1 is the stop switch, SB2 is the start switch, KM AC contactor, FR thermal relay, FU fuse. The control principle is as follows, press the start switch SB2, the AC contactor coil KM □ is amped and closed, and at the same time the KM,/, typ
Familiar with the structural characteristics of the push button switch, choose the appropriate operation switch Familiar with the structural characteristics of the push button switch, choose the appropriate operation switch
Aug .13.2022
The push button switch is an electrical product with simple structure and a wide range of uses. The structural features of the button switch are also very rich and varied, including mushroom head style, self-locking, self-resetting...